Zap ELECTRIC SCOOTER Owner's Manual download pdf (Page 11)

CHARGING

TO CHARGE ZAPPY'S BATTERY (FIG.7)

Plug the charger power

connector into the battery

charging jack.

Then, plug the ZAP

charger into a standard

110 VAC (or 220, if applic-

able) wall socket.

Please observe all safety

warnings described on

pages 14-16.

NEVER EXPOSE THE CHARGER TO WET OR DAMP CONDITIONS!

NOTE: You can charge the battery away from ZAPPY. Remove

the deck, disconnect the battery power connector, and remove the

battery. Connect the charger power connector to the power

connector on the battery.

TO DISCONNECT THE CHARGER:

First, unplug the ZAP charger from the 110 VAC (or 220 in some

countries outside the USA) wall socket.

Then, disconnect the charger power connector from the battery

charging connector.

Replace the battery charger back under the deck.

Reattach the deck.

NOTE: Your ZAPPY is equipped with a low voltage cutout. This

means that when your battery is discharged, the controller will

shut off the motor. If this happens, you must recharge ZAPPY

immediately to avoid damaging your battery permanently.

CHARGING TIME

•

The battery will usually take up to several hours to fully recharge.

Refer to the charger instructions included with your ZAPPY

to determine when your battery is completely charged.

•

Charge the battery immediately after use in order to maximize bat-

tery life. Charge the battery at room temperature if possible. Use

only the ZAP battery charger. Using any other charger may dam-

age the battery.

CHARGE BATTERY AFTER EVERY USE!

Fig.7

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 21 22

No comments

Zap ELECTRIC SCOOTER Owner's Manual Page 11