Zap ELECTRIC SCOOTER Owner's Manual download pdf (Page 12)

PRE-RIDE CHECK LIST

PERIODICALLY GO THROUGH THIS CHECKLIST TO MAKE SURE THAT YOUR ZAPPY IS

IN PROPER ADJUSTMENT FOR SAFETY AND OPTIMAL PERFORMANCE. IT IS IMPER

ATIVE THAT YOU REVIEW THIS CHECKLIST BEFORE YOUR FIRST RIDE. ALTHOUGH

YOUR ZAPPY HAS PASSED OUR QUALITY ASSURANCE PROCEDURE, IT MAY NEED

ADJUSTMENT AFTER SHIPPING.

Connect the battery power connector to the controller power

connector.

Check tire pressure: The tires on your ZAPPY should be at

least 36 psi (pounds per square inch).

Be sure all wire connections, especially battery terminals,

are tight.

Check the handlebar quick release to see that it is tight.

ALWAYS wear your ANSI or Snell-approved helmet.

NOW YOU ARE READY. HAVE A GOOD RIDE!!!

HOW TO RIDE THE ZAPPY

•

Practice makes perfect...right? Yes, it does! The more time spent

on the ZAPPY, the easier maneuvering will become. Follow the

foot placement guide below to get yourself started for safe, con-

trolled riding. Practice without applying power for balance.

•

Note: If you are left footed, or just looking for a change, place your

right foot in front, and your left foot on the rear of the ZAPPY.

•

Be sure to lean forward when giving the starting kicks. When the power

hits the front wheel, the front of the ZAPPY may lift off of the ground!

•

Both feet should be on the ZAPPY before power is applied, and the

push scooter needs to be moving.

•

Since ZAPPY is a new product, certain jurisdictions are not clear on reg-

ulations. Even law enforcement officers are not clear. Check with your

local agencies and follow all laws. When in doubt, only use the ZAPPY

as a push scooter.

ALWAYS WEAR A HELMET!

Fig.8

RIGHT

LEFT

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 21 22

No comments

Zap ELECTRIC SCOOTER Owner's Manual Page 12